User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 604 System Manual
4.8.13.2 Restoring the Default Values of Handover Negotiation at
TBS Parameters
To restore some or all of the Handover Negotiation at TBS parameters to their
default values, run the following command:
npu(config-bs-66053)# no honegotiation-tbs [defaultactiontime]
[fastrangingalloc]
You can restore only one parameter to the default values by specifying only that
parameters. For example, to restore only the fastrangingalloc parameter to the
default value, run the following command:
npu(config-bs-66053)# no honegotiation-tbs fastrangingalloc
This parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all Handover Negotiation at TBS parameters to their default value, run
the following command:
npu(config-bs-66053)# no honegotiation-tbs
4.8.13.3 Displaying Configuration Information for Handover
Negotiation at TBS Parameters
To display configuration information for Handover Negotiation at TBS parameters,
run the following command:
npu# show honegotiation-tbs bs [<(1 to 16777215 StepSize 1)
NOTE
Refer to Section 4.8.13.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no honegotiation-stbs [defaultactiontime ]
[fastrangingalloc ]
Privilege
Level
10
Command
Modes
bs configuration mode