User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 601 System Manual
4.8.12.3 Displaying Configuration Information for Handover
Negotiation at SBS Parameters
To display configuration information for Handover Negotiation at SBS parameters,
run the following command:
npu# show honegotiation-sbs bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Handover Negotiation at SBS parameters of BS 66053,
run the following command:
npu# show honegotiation-sbs bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show honegotiation-sbs bs
NOTE
Refer to Section 4.8.12.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no honegotiation-sbs [selectcoefficient ]
[max-tbs ] [min-actiontime ] [max-actiontime ]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show honegotiation-sbs bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1