User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs

4Motion 599 System Manual

4.8.12 Managing Handover Negotiation at SBS

Parameters

After enabling the BS configuration mode, you can execute the following tasks:

 Configure one or more of the Handover Negotiation at SBS parameters (refer to

Section 4.8.12.1).

 Restore the default values of some or all of the Handover Negotiation at SBS

parameters (refer to Section 4.8.12.2).

You can display configuration information for the Handover Negotiation at SBS

parameters of a selected or all existing BSs (refer to Section 4.8.12.3).

4.8.12.1 Configuring Handover Negotiation at SBS Parameters

From the BS configuration mode, run the following command:

npu(config-bs-66053)# honegotiation-sbs [selectcoefficient <(0 to 10 StepSize

0.1)>] [max-tbs <(0 to 255 StepSize 1)>] [min-actiontime <(0 to 255 StepSize 1)>]

[max-actiontime <(0 to 255 StepSize 1)>]

Command

Modes

Global command mode

To configure the Handover Negotiation at SBS Parameters:

IMPORTANT

When creating a new BS, at least one of the Handover Negotiation at SBS parameters must be

configured explicitly (even if configured to the default value).

Command

Syntax

npu(config-bs-66053)# honegotiation-sbs [selectcoefficient <(0 to

10 StepSize 0.1)> ] [max-tbs <(0 to 255 StepSize 1)> ]

[min-actiontime <(0 to 255 StepSize 1)> ] [max-actiontime <(0 to

255 StepSize 1)> ]

Privilege

Level