User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 598 System Manual
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Scan Negotiation parameters of BS 66053, run the
following command:
npu# show scanning bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show scanning bs
Command
Syntax
npu# show scanning bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display Scan Negotiation
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display Scan Negotiation
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
MaximumAttempts :<value>
MeasuringInterval(sec) :<value>
EnableAutoAcceptProfile :<value>
EnableModifyProfile :<value>
MinimumInterleavingInterval(frames) :<value>
MaximumScanDuration(frames) :<value>
MinimumBandwidthDegradationFactor :<value>
MinimumStartFrame(frames) :<value>