User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs

4Motion 595 System Manual

4.8.11 Managing Scan Negotiation Parameters

After enabling the BS configuration mode, you can execute the following tasks:

 Configure one or more of the Scan Negotiation parameters (refer to

Section 4.8.11.1).

 Restore the default values of some or all of the Scan Negotiation parameters

(refer to Section 4.8.11.2).

You can display configuration information for the Scan Negotiation parameters of

a selected or all existing BSs (refer to Section 4.8.11.3).

4.8.11.1 Configuring Scan Negotiation Parameters

From the BS configuration mode, run the following command:

npu(config-bs-66053)# scanning [max-attempts <(0 to 255 StepSize 1)>] [interval

<(0 to 100 StepSize 0.1)>] [enable-autoaccept {TRUE | FALSE}] [enable-modify

{TRUE | FALSE}] [min-interval <(2 to 255 StepSize 1)>] [max-duration <(0 to 255

StepSize 1)>] [min-degradationfactor <(0 to 1 StepSize 0.1)>] [honegotiation-sbs

<(0 to 255 StepSize 1)>]

To configure the Scan Negotiation Parameters:

IMPORTANT

When creating a new BS, at least one of the Scan Negotiation parameters must be configured

explicitly (even if configured to the default value).

Command

Syntax

npu(config-bs-66053)# scanning [max-attempts <(0 to 255 StepSize

1)> ] [interval <(0 to 100 StepSize 0.1)> ] [enable-autoaccept

{TRUE | FALSE} ] [enable-modify {TRUE | FALSE} ] [min-interval <(2

to 255 StepSize 1)> ] [max-duration <(0 to 255 StepSize 1)> ]

[min-degradationfactor <(0 to 1 StepSize 0.1)> ]

[honegotiation-sbs <(0 to 255 StepSize 1)> ]

Privilege

Level