User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 593 System Manual
4.8.10.2 Restoring the Default Values of Trigger Setup Parameters
To restore one or all of the Trigger Setup parameters to their default values, run
the following command:
npu(config-bs-66053)# no triggersetup [hysteresismargin] [timetotrigger]
[avgduration-rssi] [avgduration-cinr] [avgduration-rtd]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the hysteresismargin parameter to
the default value, run the following command:
npu(config-bs-66053)# no triggersetup hysteresismargin
This parameter will be restored to its default value, while the other parameters
will remain unchanged.
To restore all Trigger Setup parameters to their default value, run the following
command:
npu(config-bs-66053)# no triggersetup
4.8.10.3 Displaying Configuration Information for Trigger Setup
Parameters
To display configuration information for Trigger Setup parameters, run the
following command:
npu# show triggersetup bs [<(1 to 16777215 StepSize 1)
NOTE
Refer to Section 4.8.10.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no triggersetup [hysteresismargin ]
[timetotrigger ] [avgduration-rssi] [avgduration-cinr]
[avgduration-rtd ]
Privilege
Level
10
Command
Modes
bs configuration mode