User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 591 System Manual
4.8.10 Managing Trigger Setup Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Trigger Setup parameters (refer to
Section 4.8.10.1).
 Restore the default values of one or all of the Trigger Setup parameters (refer to
Section 4.8.10.2).
You can display configuration information for the Trigger Setup parameters of a
selected or all existing BSs (refer to Section 4.8.10.3).
4.8.10.1 Configuring Trigger Setup Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# triggersetup [hysteresismargin <(0 to 255 StepSize 1)>]
[timetotrigger <(0 to 255 StepSize 1)>] [avgduration-rssi <(0 to 255 StepSize 1)>]
[avgduration-cinr <(0 to 255 StepSize 1)>] [avgduration-rtd <(0 to 255 StepSize
1)>]
Display
Format
(for a
selected
Trigger)
BSIDLSB :<value>
scnReqRssiMin :<value>
Command
Modes
Global command mode
To configure the Trigger Setup Parameters:
IMPORTANT
When creating a new BS, at least one of the Trigger Setup parameters must be configured explicitly
(even if configured to the default value).