User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 587 System Manual
4.8.9 Managing Triggers Parameters
After enabling the BS configuration mode, you can configure one or more of the
Triggers parameters (refer to Section 4.8.9.1).
You can display configuration information for the Triggers parameters of a
selected or all existing BSs (refer to Section 4.8.9.2).
4.8.9.1 Configuring Triggers Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# triggers-<trigger-name> <trigger-range>
Each Trigger is configured separately. This is the general structure of the
command.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display Neighbour
Advertisement parameters of
a specific BS. Do not specify
a value for this parameter if
you want to display
Neighbour Advertisement
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
MinimumInterval-NormalLoad :<value>
MinimumInterval-HighLoad :<value>
PeriodicInterval :<value>
Command
Modes
Global command mode
To configure the Triggers Parameters: