User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 582 System Manual
4.8.7.2 Restoring the Default Values of Feedback Allocation
Parameters
To restore one or all of the Feedback Allocation non-mandatory parameters to
their default values, run the following command:
npu(config-bs-66053)# no feedbackalloc [pr-cdma] [ir-cdma] [ert-poll-enable]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the pr-cdma and ir-cdma
parameters to the default values, run the following command:
npu(config-bs-66053)# no feedbackalloc pr-cdma ir-cdma
These parameters will be restored to their default value, while the other
parameters will remain unchanged.
To restore all Feedback Allocation non-mandatory parameters to their default
value, run the following command:
npu(config-bs-66053)# no feedbackalloc
4.8.7.3 Displaying Configuration Information for Feedback
Allocation Parameters
To display configuration information for Feedback Allocation parameters, run the
following command:
npu# show feedbackalloc bs [<(1 to 16777215 StepSize 1)
NOTE
Refer to Section 4.8.7.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no feedbackalloc [pr-cdma ] [ir-cdma ]
[ert-poll-enable]
Privilege
Level
10
Command
Modes
bs configuration mode