User Manual

Chapter 4 - Operation and Administration Using the CLI Managing ODUs
4Motion 491 System Manual
4.6.1.3.2 Restoring the Default Values of ODU Reserved Parameters
To restore the ODU Reserved parameters to their default value, run the following
command:
npu(config-odu-params-1)# no odu-reserved [reserved-1] [reserved-2]
[reserved-3] [reserved-4] [reserved-5] [reserved-6] [reserved-7]
[reserved-8] [reserved-9]
You can restore only selected parameters to their default value by specifying only
those parameter. For example, to restore only the reserved-1 parameter to its
default values, run the following command:
npu(config-odu-params-1)# no odu-reserved reserved-1
This parameter will be restored to the default value, while the other parameters
will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-odu-params-1)# no odu-reserved
NOTE
Refer to Section 4.6.1.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-odu-params-1)# no odu-general [heater-existence]
[external-cavity-filter-existence]
Privilege
Level
10
Command
Modes
odu-params configuration mode
NOTE
Refer to Section 4.6.1.2.2 for a description and default values of these parameters.
Command
Syntax
npu(config-odu-params-1)# no odu-reserved [reserved-1]
[reserved-2] [reserved-3] [reserved-4] [reserved-5
] [reserved-6]
[reserved-7] [reserved-8] [reserved-9]