User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Sectors
4Motion 768 System Manual
4.9.1.3 Restoring Default Values for Sector Configuration
Parameters
After enabling the Sector Parameters configuration mode you can restore the
default values for parameters in the following parameters tables:
 Sector Definition (refer to Section 4.9.1.3.1)
 Sector Reserved (refer to Section 4.9.1.3.2)
4.9.1.3.1 Restoring the Default Values of Sector Definition Parameters
To restore the non-mandatory sector-name parameter to the default value, run
the following command:
npu(config-sector-params-1)# no sector-definition [sector-name]
Since there is only one non-mandatory parameters, you can use any one of the
following two commands to restore the sector-name to its default value:
npu(config-sector-params-1)# no sector-definition
or:
npu(config-sector-params-1)# no sector-definition sector-name
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[reserved-N <string
(32)>] (N=1-4)
Reserved parameter number N Optional null (an
empty
string)
A string of 32
printable
characters.
Command
Modes
sector-params configuration mode
NOTE
Refer to Section 4.9.1.2.1 for a description and default values of this parameter.