User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Sectors
4Motion 765 System Manual
To create a new Sector object, the mandatory heading and width parameters must
be specified. Run the following command to create a new Sector object and enable
the parameters configuration mode for this ODU:
npu (config)# sector-params <(1 to 6 StepSize 1)> [heading <(0 to 359 StepSize
1)> width <(0 to 359 StepSize 1)>]
A new Sector object is created with default values for all parameters except to the
mandatory heading and width parameters.
For example, to create Sector 1 object and enable the parameters configuration
mode for this Sector, where the heading is 180 and width is 90, run the following
command:
npu (config)# sector-params 1 heading 180 width 90
After enabling the Sector Parameters configuration mode for a Sector you can
execute any of the following tasks:
 Configure one or more of the parameters tables of the Sector (refer to
Section 4.9.1.2)
 Restore the default values of non-mandatory parameters in one or more of the
parameters tables of the Sector (refer to Section 4.9.1.3)
After executing the above tasks, you can terminate the Sector Parameters
configuration mode (refer to Section 4.9.1.4) and return to the global
configuration mode.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu (config)# sector-params <(1 to 6 StepSize 1)> [heading <(0 to 359 StepSize 1)> width <(0
to 359 StepSize 1)> ]
Privilege
Level
10