User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 758 System Manual
You can restore only some parameters to the default values by specifying only
those parameter. For example, to restore only the reserved-1 and reserved-2
parameters to the default values, run the following command:
npu(config-bs-66053)# no bs-reserved reserved-1 reserved-2
These parameters will be restored to the default value, while the other parameters
will remain unchanged.
To restore all BS Reserved parameters to their default value, run the following
command:
npu(config-bs-66053)# no bs-reserved
4.8.31.3 Displaying Configuration Information for BS Reserved
Parameters
To display configuration information of BS Reserved parameters, run the following
command:
npu# show bs-reserved bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the BS Reserved parameters of BS 66053, run the following
command:
npu# show bs-reserved bs 66053
NOTE
Refer to Section 4.8.31.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no bs-reserved [reserved-1 ] [reserved-2 ]
[reserved-3 ] [reserved-4 ] [reserved-5 ] [reserved-6 ]
[reserved-7 ] [reserved-8 ] [reserved-9 ] [reserved-10 ]
[reserved-11 ] [reserved-12 ] [reserved-13 ] [reserved-14 ]
[reserved-15 ] [reserved-16 ] [reserved-17 ] [reserved-18 ]
[reserved-19 ] [reserved-20 ] [reserved-21 ]
Privilege
Level
10
Command
Modes
bs configuration mode