User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 756 System Manual
4.8.31 Managing BS Reserved Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the BS Reserved parameters (refer to
Section 4.8.31.1).
 Restore the default values of some or all of the BS Reserved parameters (refer
to Section 4.8.31.2).
You can display configuration information for the BS Reserved parameters of a
selected or all existing BSs (refer to Section 4.8.31.3).
4.8.31.1 Configuring BS Reserved Parameters
As the name implies, the reserved parameters table enables configuring up to 21
parameters that are reserved for possible future use. In the current release none
of the reserved parameters is being used.
To configure the BS reserved parameters, run the following command:
npu(config-bs-66053-1)# bs-reserved [reserved-1 <string (32)> ]
[reserved-2 <string (32)> ] [reserved-3 <string (32)> ] [reserved-4
<string (32)> ] [reserved-5 <string (32)> ] [reserved-6 <string
(32)> ] [reserved-7 <string (32)> ] [reserved-8 <string (32)> ]
[reserved-9 <string (32)> ] [reserved-10 <string (32)> ]
[reserved-11 <string (32)> ] [reserved-12 <string (32)> ]
[reserved-13 <string (32)> ] [reserved-14 <string (32)> ]
[reserved-15 <string (32)> ] [reserved-16 <string (32)> ]
[reserved-17 <string (32)> ] [reserved-18 <string (32)> ]
[reserved-19 <string (32)> ] [reserved-20 <string (32)> ]
[reserved-21 <string (32)> ]
Command
Modes
Global command mode