User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 744 System Manual
4.8.28.5.3 Displaying Configuration Information for Handover Ranging
Parameters
To display configuration for the Handover Ranging parameters, run the following
command:
npu# show ranging-horng bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Handover Ranging parameters of BS 66053, run the
following command:
Command
Syntax
npu# show ranging-bwreq bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display the Ranging
Bandwidth Request
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display the Ranging
Bandwidth Request
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
NumberofBandwidthRequestCodes :<value>
InitialBackoffWindowSizeforBandwidthRequest :<value>
FinalBackoffWindowSizeforBandwidthRequest :<value>
Command
Modes
Global command mode