User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 741 System Manual
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all Ranging Timing Correction parameters to their default value, run
the following command:
npu(config-bs-66053-ranging)# no timingcorrection
4.8.28.4 Terminating the Ranging Configuration Mode
Run the following command to terminate the Ranging configuration mode:
npu(config-bs-66053-ranging)# exit
NOTE
Refer to Section 4.8.28.2.6 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-1-ranging)# no timingcorrection [thrshld-correction ]
[thrshld-rngstatus ]
Privilege
Level
10
Command
Modes
bs ranging configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the CRanging configuration mode:
npu(config-bs-66053-ranging)# apply
Command
Syntax
npu(config-bs-66053-ranging)# exit
Privilege
Level
10
Command
Modes
bs ranging configuration mode