User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 740 System Manual
npu(config-bs-66053-ranging)# no periodicrng [codes]
[init-backoff-window-size] [final-backoff-window-size]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the codes parameter to the default
value, run the following command:
npu(config-bs-66053-ranging)# no periodicrng codes
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all Periodic Ranging parameters to their default value, run the following
command:
npu(config-bs-66053-ranging)# no periodicrng
4.8.28.3.6 Restoring the Default Values of Ranging Timing Correction
Parameters
To restore one or all of the Ranging Timing Correction parameters to their default
values, run the following command:
npu(config-bs-1-ranging)# no timingcorrection [thrshld-correction]
[thrshld-rngstatus]
You can restore only one parameter to the default values by specifying only that
parameters. For example, to restore only the thrshld-correction parameter to the
default value, run the following command:
npu(config-bs-66053-ranging)# no timingcorrection thrshld-correction
NOTE
Refer to Section 4.8.28.2.5 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-ranging)# no periodicrng [codes ]
[init-backoff-window-size ] [final-backoff-window-size ]
Privilege
Level
10
Command
Modes
bs ranging configuration mode