User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 738 System Manual
4.8.28.3.3 Restoring the Default Values of Handover Ranging Parameters
To restore one or all of the Handover Ranging parameters to their default values,
run the following command:
npu(config-bs-66053-ranging)# no horng [codes] [init-backoff-window-size]
[final-backoff-window-size]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the codes parameter to the default
value, run the following command:
npu(config-bs-66053-ranging)# no horng codes
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all Handover Ranging parameters to their default value, run the
following command:
npu(config-bs-66053-ranging)# no horng
NOTE
Refer to Section 4.8.28.2.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-ranging)# no bwreq [codes ]
[init-backoff-window-size ] [final-backoff-window-size ]
Privilege
Level
10
Command
Modes
bs ranging configuration mode
NOTE
Refer to Section 4.8.28.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-ranging)# no horng [codes ]
[init-backoff-window-size ] [final-backoff-window-size ]