User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 731 System Manual
4.8.28.2.2 Configuring Ranging Bandwidth Request Parameters
To configure the Ranging Bandwidth Request parameters, run the following
command:
npu(config-bs-66053-ranging)# bwreq [codes <(0 to 255 StepSize 1)>]
[init-backoff-window-size <(0 to 15 StepSize 1)>] [final-backoff-window-size <(0 to
15 StepSize 1)>]
Command
Modes
bs ranging configuration mode
IMPORTANT
When creating a new BS, at least one of the Ranging Bandwidth Request parameters must be
configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-ranging)# bwreq [codes <(0 to 255 StepSize 1)> ]
[init-backoff-window-size <(0 to 15 StepSize 1)> ]
[final-backoff-window-size <(0 to 15 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
codes <(0 to 255
StepSize 1)>
Number of Bandwidth Request
Codes.
Note that the sum of initial
ranging codes, periodic ranging
codes, bandwidth request
codes, handover ranging codes
and start of ranging codes
should be equal to or less than
256.
Optional 14 0 - 255
init-backoff-window
-size <(0 to 15
StepSize 1)>
Initial backoff window size for
contention BW requests;
expressed as a power of 2.
Optional 0 0 - 15