User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 722 System Manual
You can display configuration for the Management Alarm Threshold parameters of
a selected or all existing BSs (refer to Section 4.8.26.3).
4.8.26.1 Configuring Management Alarm Thresholds Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# mngmnt-alrmthrshld [retransmit-rate <(0 to 100
StepSize 1)>] [drop-rate <(0 to 100 StepSize 1)>]
4.8.26.2 Restoring the Default Values of Management Alarm
Thresholds Parametes
To restore the default values of some or all of the Management Alarm Thresholds
parameters, run the following command:
To configure the Management Alarm Thresholds parameters:
Command
Syntax
npu(config-bs-66053)# mngmnt-alrmthrshld [retransmit-rate <(0 to
100 StepSize 1)> ] [drop-rate <(0 to 100 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
retransmit-rate <(0 to
100 StepSize 1)>
Alarm Threshold for
retransmission rate of
control messages (in %).
Optional 30 0-100
drop-rate <(0 to 100
StepSize 1)>
Alarm Threshold for dropn
rate of control messages
(in %).
Optional 10 0-100
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, at least one of the Management Alarm Thresholds parameters must be
configured explicitly (even if configured to the default value).