User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 720 System Manual
4.8.25.5.3 Displaying Configuration Information for All Control Traffic QoS
Marking Rules Parameters
To display configuration for all Control Traffic QoS Marking Rules parameters,
run the following command:
npu# show ctrltrafficqos-all bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display all Control Traffic QoS Marking Rules parameters of BS
66053, run the following command:
npu# show ctrltrafficqos-all bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show ctrltrafficqos-all bs
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
IntraASNDSCP :<value>
IntraASN802.1pPriority :<value>
Command
Modes
Global command mode
Command
Syntax
npu# show ctrltrafficqos-all bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1