User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 714 System Manual
4.8.25.2.2 Configuring the Intra ASN Traffic QoS Marking Rules
To configure the Intra ASN Traffic QoS Marking Rules parameters, run the
following command:
npu(config-bs-66053-ctrltrafficqos)# intraasn [dscp <(0 to 63 StepSize 1)>]
[intra8021p <(0 to 7 StepSize 1)>]
Command
Syntax
npu(config-bs-66053-ctrltrafficqos)# intmngmnt [dscp <(0 to 63
StepSize 1)> ] [inter8021p <(0 to 7 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
dscp <(0 to 63
StepSize 1)>
DSCP priority value to be
used for marking of internal
management traffic
Optional 0 0 - 63
inter8021p <(0 to 7
StepSize 1)>
802.1p priority value to be
used for marking of internal
management traffic
Optional 0 0 - 7
Command
Modes
bs control traffic qos marking rules (ctrltrafficqos) configuration mode
IMPORTANT
When creating a new BS, at least one of the Intra ASN Traffic QoS Marking Rules parameters must
be configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-ctrltrafficqos)# intraasn [dscp <(0 to 63 StepSize
1)> ] [intra8021p <(0 to 7 StepSize 1)> ]
Privilege
Level
10