User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 713 System Manual
After executing the above tasks, you can terminate the Control Traffic QoS
Marking Rules configuration mode (refer to Section 4.8.25.4) and return to the BS
configuration mode.
Note that for properly completing the Control Traffic QoS Marking Rules
configuration the apply command must be executed prior to exiting the Control
Traffic QoS Marking Rules configuration mode.
4.8.25.2 Configuring Control Traffic QoS Marking Rules Parameters
After enabling the Control Traffic QoS Marking Rules configuration mode you can
configure the following parameters tables:
 Internal Management (refer to Section 4.8.25.2.1)
 Intra ASN (refer to Section 4.8.25.2.2)
4.8.25.2.1 Configuring Internal Management Traffic QoS Marking Rules
Parameters
To configure the Internal Management Traffic QoS Marking Rules, run the
following command:
npu(config-bs-66053-ctrltrafficqos)# intmngmnt [dscp <(0 to 63 StepSize 1)>]
[inter8021p <(0 to 7 StepSize 1)>]
Command
Syntax
npu(config-bs-66053)# ctrltrafficqos
Privilege
Level
10
Command
Modes
bs configuration mode
IMPORTANT
After completing the Control Traffic QoS Marking Rules configuration,do not forget to execute the
apply command before exiting the Control Traffic QoS Marking Rules configuration mode:
npu(config-bs-66053-ctrltrafficqos)# apply
IMPORTANT
When creating a new BS, at least one of the Internal Management Traffic QoS Marking Rules
parameters must be configured explicitly (even if configured to the default value).