User Manual

4Motion Configuration Using AlvariSTAR 4Motion Configuration
Annex A. CPEs Support
This example describes the following:
1. configuration of SI, SG, SP, SF for all other CPEs (not R2)
2. Working with IP mode (thus far, VLAN mode was described)
A.1. Service Interface
Service interface configuration
Type IP-in IP is used
A.2. service Group
IMPORTANT
It is important to verify that the 'Vendor Class Identifier' parameter is configured according to
the value of Option 60 located in the DHCP-discover message sent by the CPE.
For WCM and RGW 'Vendor Class Identifier'= MSFT 5.0
4Motion - DN1031 34