User Manual

4Motion - DN1031 7
4Motion Configuration Using AlvariSTAR 4Motion Configuration
BS
BS
BS
External
ASN GW
BS
BS
BS
Cell Site 1
CSGw
card
External Layer 2Eth
Switch supporting
VLANs
VLANs
Bearer, NMS
VLANs
VLAN Bearer
VLAN NMS
NMS
IP
Network
NMS
System
NMS Master
Agent
NMS
Module
Agents
NMS
Module
Agents
IP of Backbone NMS
IP of Bearer
IP of Cell Site Internal NMS
CSGw
card
NMS Master
Agent
BS
applications
BS
applications
Bearer, NMS
Cell Site 2
Bearer
(R6/R8/R4)
IP Network
ASNGW
application
ASNGW
application
Figure 2: In-band Connectivity Mode Diagram
3.2.2 IP Interfaces Settings
Select Connectivity > IP Interface from the navigation tree.
The list contains the three available IP interfaces. The external management
interface was already configured in Section
3.1.2.
Bearer IP interface should be properly configured.
3.2.2.1 Interface Configuration
Changing the bearer or the management interfaces depend by the network
setup. To modify the IPs or any other values do the following:
1. Change the administrative status to Down.
2. Click on the Apply button.
3. Change the IP and/or any other value except for VLAN ID.
4. Click on the Apply button.
5. Change the administrative status back to UP.
6. Click on the Apply button to accept the changes.