User Manual

4Motion Configuration Using AlvariSTAR 4Motion Configuration
5. If you performed Software Upgrade, you must upload the Vendor
Configuration File. You can do this via AlvariSTAR (see Annex B).
3 4Motion Configuration
3.1 Configuration Via the CLI
The following should be configured via the CLI
3.1.1 Site ID Configuration
Site Identifier is a mandatory parameter and is used as the site's unique ID
on the net.
Valid values – any integer
npu# c t
npu(config)# site identifier 246
npu(config)# exit
npu# wr
Configurations saved successfully
3.1.2 External Management IP Address Configuration
External Management IP address must be configured in order to have
management configuration between the NPU and AlvariSTAR.
npu# c t
npu(config)# interface external-mgnt
npu(config-if)# shutdown
npu(config-if)# ip address 10.0.22.246 255.255.255.0
npu(config-if)# no shutdown
npu(config-if)# exit
npu(config)# exit
npu#
npu# wr
Configurations saved successfully
3.1.3 SNMP Communities
The SNMP communities are essential for managing the device.
4Motion - DN1031 3