User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 700 System Manual
4.8.23 Managing Handover Control Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Handover Control parameters (refer to
Section 4.8.23.1).
 Restore the default values of some or all of the Handover Control parameters
(refer to Section 4.8.23.2).
You can display configuration information for the Handover Control parameters of
a selected or all existing BSs (refer to Section 4.8.23.3).
4.8.23.1 Configuring Handover Control Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# hoctrl [enable-teksharing <hex-string>] [rtxtimer <(0 to
255 StepSize 1)>]
To configure the Handover Control parameters:
Command
Syntax
npu(config-bs-66053)# hoctrl [enable-teksharing <hex-string>]
[rtxtimer <(0 to 255 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values