User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 697 System Manual
[activemsthrshld <(0
to 1024 StepSize 1)> ]
Threshold for the number
of MSs in active operation
state (not Idle) served by
the BS. Exceeding this
threshold will set the
alarm “Excessive MS
number”.
A value of 0 means that
the alarm is disabled.
Optional 0 0 to 1024
[maxeaproundsthrshl
d <(0 to 100 StepSize
1)> ]
Threshold for the number
of EAP rounds in one
direction in the same EAP
session. When exceeding
this threshold; alarm is
set. May be used to
protect the system from
hazard EAP sessions with
extreme number of
messaging round trips. A
value of "0" means the
alarm is disabled.
A value of 0 means that
the alarm is disabled.
Optional 0 0 to 100
[nonauth-macctrlratet
hrshld <(0 to 120000
StepSize 1)> ]
Threshold for alarm for
exceeding non-authentic
MAC control rate, in Kbps
A value of 0 means that
the alarm is disabled.
Optional 0 0 to 120000
[nonauth-pduratethrsh
ld <(0 to 120000
StepSize 1)> ]
Threshold for alarm for
exceeding non-authentic
PDU rate (in Kbps).
A value of 0 means that
the alarm is disabled.
Optional 0 0 to 120000
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, the Authentication dflt-auth-ip-address mandatory parameter must be
configured.