User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 796 System Manual
4.10.2.4.2 Resetting Statistics for the Authenticator Functionality
Run the following command to reset statistics for the Authenticator functionality:
npu# clear authenticator statistics
After you run this command, the statistics counter is reset to 0.
4.10.2.5 Managing Statistics for the Data Path Function
This section describes the commands to be used for:
 “Displaying Statistics for the Data Path Function” on page 796
 “Resetting Data Path Statistics” on page 801
4.10.2.5.1 Displaying Statistics for the Data Path Function
You can display statistics counters that provide information about the data path
registration, pre-registration and de-registration requests and responses handled
by the data path function. The following table lists the statistics counters for the
data path function:
Command
Modes
Global command mode
NOTE
The privilege level of this command is 15.
Table 4-35: Statistics Counters for the Data Path Function
Statistics Counter Indicates the number of...
dpPathRegReqRx Path registration requests received by
the data path function (NPU).
dpPathRegReqTx Path registration requests transmitted
by the data path function (NPU). This
does not include the number of
retransmissions.
dpPathRegReqRtx Path registration requests retransmitted
by the data path function (NPU).
dpPathRegReqDrop Path registration requests dropped by
the data path function (NPU).
dpPathRegRprtRx Path registration reports received by the
data path function (NPU).