User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 791 System Manual
4.10.2.3.2 Resetting Statistics for the PMIP Client Functionality
Run the following command to reset statistics for the PMIP client functionality:
npu# clear pmip-client statistics
After you run this command, the statistics counter is reset to 0.
4.10.2.4 Managing Statistics for the Authenticator Functionality
This section describes the commands to be used for:
 “Displaying Statistics for the Authenticator Functionality” on page 791
 “Resetting Statistics for the Authenticator Functionality” on page 796
4.10.2.4.1 Displaying Statistics for the Authenticator Functionality
You can display statistics counters that provide information about the EAP
messages, and successful and failed authentications handled by the
Authenticator functionality. The following table lists the statistics counters for the
Authenticator functionality:
Display
Format
PMIP-Client Statistics :
mipNumPmipMS = <value>
mipRRPRx = <value>
mipRRQTx = <value>
mipRRQRtx = <value>
mipRRPErr = <value>
mipMsSoftLifetimeExp = <value>
mipIpAllocFailed = <value>
mipIpDeallocFailed = <value>
mipFaMigFailed = <value>
mipInvalidEvent = <value>
Command
Modes
Global command mode
NOTE
The privilege level of this command is 15.