User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 692 System Manual
4.8.21 Managing BS Bearer Interface Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Bearer Interface parameters (refer to
Section 4.8.21.1).
 Restore the default values of some or all of the Bearer Interface parameters
(refer to Section 4.8.21.2).
You can display configuration information for the Bearer Interface parameters of a
selected or all existing BSs (refer to Section 4.8.21.3).
4.8.21.1 Configuring Bearer Interface Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# bearer [ip-address <ip address>] [ip-subnetmask <ip
address>] [dflt-gw <ip address>] [mtu-size <(1500 to 9000 StepSize 1)>]
[linkusage-hardthrshld <(0 to100 StepSize 1)>]
Command
Modes
Global command mode
To configure the Bearer Interface Parameters:
Command
Syntax
npu(config-bs-66053)# bearer [ip-address <ip address> ]
[ip-subnetmask <ip address> ] [dflt-gw <ip address> ] [mtu-size
<(1500 to 9000 StepSize 1)> ] [linkusage-hardthrshld <(0 to100
StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Defaul
t Value
Possible
Values
[ip-address <ip address>
]
The IP address of the
bearer interface of the
BS
Mandatory
when creating a
new BSl
N/A IP address