User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 785 System Manual
 “Managing Statistics for the DHCP Server” on page 808
 “Managing Statistics for the DHCP Proxy” on page 810
 “Managing Statistics for the DHCP Relay” on page 812
 “Managing Statistics for the SFA Functionality” on page 814
4.10.2.1 Managing Statistics for the IGMP Functionality
This section describes the commands to be used for:
 “Displaying Statistics for the IGMP Functionality” on page 785
 “Resetting Statistics for the IGMP Functionality” on page 786
4.10.2.1.1 Displaying Statistics for the IGMP Functionality
You can display statistics counters that provide information about the IGMP
queries received and transmitted. The following table lists the statistics counters
for the IGMP functionality:
Run the following command to display statistics for the IGMP functionality:
npu# show igmp statistics
IMPORTANT
The IGMP functionality is not supported in the current release.
Table 4-31: Statistics Counters for the IGMP Functionality
Statistics Counter Indicates the number of...
igmpQueryRx IGMP queries received by the NPU.
igmpReportRx IGMP reports received by the NPU.
igmpReportTx IGMP reports transmitted by the NPU.
igmpErrQueryRx IGMP erroneous queries received by
the NPU.
igmpErrReportRx IGMP erroneous reports received by
the NPU.
igmpMcastGroups Active IGMP multicast groups.
igmpInvalidEvent invalid events that have occurred
because of receipt of IGMP messages.