User Manual

Chapter 4 - Operation and Administration Using the CLI Monitoring Performance of Hardware and Software
4Motion 784 System Manual
4.10.2 Monitoring Software Components
This section describes the following procedures for monitoring the following
software components:
 “Managing Statistics for the IGMP Functionality” on page 785
 “Managing statistics for the MIP-FA functionality” on page 786
 “Managing Statistics for the PMIP Client Functionality” on page 789
 “Managing Statistics for the Authenticator Functionality” on page 791
 “Managing Statistics for the Data Path Function” on page 796
 “Managing Statistics for the Context Function” on page 801
 “Managing Statistics for the MS State Change Functionality” on page 803
 “Managing Statistics for RADIUS” on page 806
NOTE
An error may occur if you have not configured a unique identifier for the 4Motion shelf.
Command
Syntax
npu# show site identifier
Privilege
Level
1
Display
Format
Site Id : <Device ID>
Command
Modes
Global command mode
IMPORTANT
The software components listed in this section are available only if you are operating the NPU in the
ASN-GW mode. Skip this section if you are operating the NPU in the transparent mode.