User Manual

Chapter 2 - Installation Connecting the GPS Cables
4Motion 96 System Manual
2.6 Connecting the GPS Cables
The Outdoor GPS Receiver is connected to the GPS/SYNC IN connector. Before
connecting the cable, make sure that the length of the cable is sufficient to reach
the NPU.
1 Connect the 12-pin round connector (female) of the Cat. 5E Ethernet cable to
the male connector of the surge protector. Use the groove on the cable
connector (indicated by an arrow) as a guide. It aligns with the tenon in the
connector on the surge protector side. Turn the locking ring on the cable
connector clockwise to secure the connection. Do not over-tighten.
2 Fix the cable onto the pole using a cable strip. Route the cable to the location
selected for the indoor equipment.
3 Crimp the other end of the Cat. 5E Ethernet cable with an RJ-45 connector
and connect it to the indoor GPS adapter cable. Connect the other end of the
indoor GPS adapter cable to GPS/SYNC IN connector.
To connect the Ethernet cable: