User Manual

Installation Instructions for Operating in the FCC WCS C and D bands TDD
- 2 -
Installing the Filter
1. Attach the Filter to the pole using the two metal bands, as shown below. The Filter must be installed with the
RF connectors facing downward.
2. Connect the ANT RF port of the ODU to the INPUT connector of the Filter.
3. Connect the OUTPUT connector of the Filter to the antenna.
Operation
When configuring the Frequency and Bandwidth parameters, the following rules must be followed:
1. The frequency must be either 2316.75 or 2348.25 MHz.
2. The Bandwidth must be 3.5 MHz
P/N 215656 May 2010