User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 455 System Manual
* After configuring at least one general BS parameter (see “Managing BS General
Parameters” on page 458
), even when configured to its default value, all tables with no
manadary parameters are created automatically, with all parameters set to their default value.
Otherwise, for each of the following tables you must enter the configuration mode and execute the
Apply command before exiting the configuration mode:
 Power Control Levels and Policies
 Control Traffic QoS Marking Rules
 Ranging Parameters
“Managing Authentication Relay
Parameters” on page 591
dflt-auth-ip-address No
“Managing Bearer Traffic QoS Marking
Rules” on page 597
enable-srvcflow-mediaflowtype
srvcflow-mediaflowtype (if
enable-srvcflow-mediaflowtype is set to
True)
Yes
“Managing Control Traffic QoS Marking
Rules” on page 605
No*
“Managing ID-IP Mapping Parameters”
on page 614
nw-node-id (Next Hop BS ID)
nw-node-ip
No
“Managing Ranging Parameters” on
page 617
No*
“Managing Alarm Threshold Parameters”
on page 621
No
“Managing BS Reserved Parameters” on
page 627
No
“Managing the BS Keep-Alive
Functionality” on page 627
No
“Managing the BS Idle Mode
Parameters” on page 633
No
“Managing Scheduler Parameters” on
page 637
No
Table 3-30: Tasks for Configuring a BS
Task Mandatory Parameters apply required