User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing Antennas
4Motion 450 System Manual
3.7.6 Displaying Configuration Information for
Antennas
To display configuration information of a specific or all Antennas, run the
following command:
npu# show antenna [antenna-no <(1 to 28 StepSize 1)>]
Specify the Antenna number (1-28) if you want to display configuration
information for a particular Antenna. Do not specify values for this parameter if
you want to view configuration information for all existing Antennas.
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 28 StepSize 1)> The Antenna number Mandatory N/A 1-28
Command
Modes
Global configuration mode
Command
Syntax
npu# show antenna [antenna-no <(1 to 28 StepSize 1)>]
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[antenna-no <(1 to
28 StepSize 1)> ]
The number of the Antenna
Specify a value for this
parameter if you want to
display the parameters of a
specific Antenna. Do not
specify a value for this
parameter if you want to
display the parameters of all
Antennas.
Optional N/A 1-28