User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing Antennas
4Motion 444 System Manual
3.7 Managing Antennas
Up to 28 Antenna objects, identified by the Antenna number (1-28), can be
created and configured.
1 Enable the Antenna configuration mode for the selected Antenna (refer to
Section 3.7.1)
2 You can now execute any of the following tasks:
» Configure one or more of the Antenna parameters (Section 3.7.2)
» Restore the default value of some or all of the Antenna parameters (refer to
Section 3.7.3)
3 Terminate the Antenna configuration mode (refer to Section 3.7.4)
In addition, you can, at any time, display configuration information for one or all
of the Antennas (refer to Section 3.7.6) or delete an existing Antenna (refer to
Section 3.7.5).
3.7.1 Enabling the Antenna Configuration
Mode\Creating an Antenna
To configure the parameters of an Antenna, first enable the Antenna configuration
mode for the specific Antenna. Run the following command to enable the Antenna
configuration mode for an Antenna:
npu (config)# antenna <(1 to 28 StepSize 1)>
When using this command to create a new Antenna, a new Antenna object is
created with default values for all parameters.
To configure an Antenna:
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.