User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing AUs
4Motion 422 System Manual
npu(config-au-1)# no connectivity
3.5.4 Terminating the AU Configuration Mode
Run the following command to terminate the au configuration mode:
npu(config-au-1)# exit
3.5.5 Deleting an AU Object
Run the following command to delete an AU object:
npu(config)# no au <(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>
NOTE
Refer to Section 3.5.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-au-1)# no connectivity [maxframesize] [bearervlanid]
[service-ip] [service-mask] [service-next-hop]
Privilege
Level
10
Command
Modes
au configuration mode
Command
Syntax
npu(config-au-1)# exit
Privilege
Level
10
Command
Modes
au-1 configuration mode
IMPORTANT
An associated AU (specified in a Sector Association) cannot be deleted.