User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing AUs
4Motion 414 System Manual
3.5 Managing AUs
Up to seven AU objects can be created and configured, corresponding to the AU
cards that can be installed in slots 1-4, 7-9 of the shelf.
1 Enable the AU configuration mode for the selected AU (refer to Section 3.5.1)
2 You can now execute any of the following tasks:
» Configure one or more of the parameters tables of the AU (refer to
Section 3.5.2)
» Restore the default values of parameters in one or more of the parameters
tables of the AU (refer to Section 3.5.3)
3 Terminate the AU configuration mode (refer to Section 3.5.4)
In addition, you can, at any time, display configuration and status information for
each of the parameters tables of the AU (refer to Section 3.5.6) or delete an
existing AU object (refer to Section 3.3.11.11.5).
To configure an AU:
NOTE
The AU reserved parameters table enables configuring up to 9 parameters that are reserved for
possible future use. In the current release none of the reserved parameters is being used.
Therefore, the following commands are not applicable:
 Configure reserved parameters: npu(config-au-<N>)# au-reserved [reserved-1 <string (32)>]
[reserved-2 <string (32)>] [reserved-3 <string (32)>] [reserved-4 <string (32)>] [reserved-5
<string (32)>] [reserved-6 <string (32)>] [reserved-7 <string (32)>] [reserved-8 <string (32)>]
[reserved-9 <string (32)>]
 Restore default values of reserved parameters: npu(config-au-<N>)# no au-reserved
[reserved-1] [reserved-2] [reserved-3] [reserved-4] [reserved-5] [reserved-6] [reserved-7]
[reserved-8] [reserved-9].
 Display configured values of reserved parameters: npu# show au-reserved au [<(1 to 4
StepSize 1) | (7 to 9 StepSize 1)>].