User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 402 System Manual
3.3.15.4.2 Disabling Dry-contact Input Alarms
To disable (block) a dry contact input alarm mapped to a specific alarm condition,
run the following command:
npu(config)# no dry-contact IN <alarm_num (1-8)>
Command
Modes
Global configuration mode
NOTE
For more information about mapping dry contact alarms to an alarm condition, refer to
“Mapping
a Dry-contact Input Alarm to an Alarm Condition” on page 399
. For more information
about displaying the alarm condition currently mapped to an alarm, refer to
“Displaying
Configuration Information for Dry-contact Input/Output Alarms” on page 406
.
Command
Syntax
npu(config)# no dry-contact IN <alarm_num (1-8)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<alarm_num
(1-8)>
Indicates the alarm number of
the dry contact input alarm
alarm that is to be disabled.
The value of this parameter
should be between 1 and 8.
For more information about
the pin numbers that
correspond to the alarm
number, refer
Table 3-28.
Mandatory N/A 1-8
Command
Modes
Global configuration mode