User's Manual
Appendix B - Software Upgrade Upgrading the AU
4Motion 701 System Manual
B.3.1.3 Step 3: Creating the AU-to-Image Mapping
After you have downloaded the AU image to the NPU flash, you can map this
image to a specific AU slot. You can also use this image to create the default
AU-to-image mapping.
To create an AU slot ID-to-image mapping, run the following command:
npu(config)# map au {<au slot-id|default>} <image name>
Specify the slot ID if you want to map the image to a specific AU slot. Specify
default if you want to use this as the default mapping for all AU cards for which
a mapping does not exist.
Command
Modes
Global configuration mode
IMPORTANT
If you are inserting/re-inserting the AU card, run this command before inserting and powering up the
AU card.
IMPORTANT
Always create a default AU-to-image mapping to be used for booting one or more AU cards, before
inserting/re-inserting the AU card.
Command
Syntax
npu(config)# map au {<au slot-id|default>} <image name>