User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 390 System Manual
3.3.15.2.4 Configuring the Position
The position configuration enables setting the location’s parameters when GPS is
not used (Type=None).
To configure the position parameters, run the following command:
npu(config)# set position ([Latitude <xxx.xxx,N/S>] [Longitude
<xxx.xxx,E/W>] [Altitude (-300.0 - 9000.0)])
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
UTC
<HH:MM:SS,DD/M
M/YYYY>
Indicates the UTC time to be
used for 4Motion if not
available from GPS.
Optional N/A Use the format:
HH:MM: SS,
DD/MM/YYYY
LocalUTCDiff
<+/-HH:MM>
The local offset from UTC Optional +00:00 +/-HH:MM
HH: -12 to +13
MM: 00 or 30
DST <(0-2)> Daylight Saving Time offset of
the local clock
Optional 0 0-2
Command
Modes
Global configuration mode
IMPORTANT
An error may occur if :
1) Latitude, longitude and altitude are configured while GPS type is not "None".
2) Latitude is not in valid format i.e. lll.mmm,a where a is either N or S
3) Longitude is not in valid format i.e. lll.mmm,a where a is either E or W.
4) Altitude is not in valid range i.e. +-300.0 to 9000.0.
Command
Syntax
npu(config)# set position ([Latitude <xxx.xxx,N/S>] [Longitude
<xxx.xxx,E/W>] [Altitude (-300.0 - 9000.0)])
Privilege
Level
10