User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration
4Motion 388 System Manual
3.3.15.2.3 Configuring the Date and Time
The UTC time is used to configure the following:
 Local time: Differs from the UTC time with respect to the value you have
specified for the localUTCDiff and DST parameters. The local time is equal to
the sum of the UTC time, the value of the localUTCDiff parameter (local
offset from UTC time) and DST (daylight saving time offset). For more
Type {Trimble
| None}]
Indicates the type of GPS
connected to 4Motion.
Optional Trimble
 Trimble
 None
[HoldoverTimeo
ut
<expiry_interv
al (0-2880)>]
Indicates the period, in
minutes, for which the NPU
provides holdover when the
GPS loses synchronization
with its satellites.
Optional 720 0 - 2880
[HoldoverPassT
xOperationStop
{True |
False}]
Indicates whether the AU
modules should stop data
transmission if the GPS loses
synchronization with its
satellites and the holdover
timeout has occurred.
Optional True
 True
 False
[AlmanacUsable
Time
<expiry-interv
al(0-4320)>]
Indicates the maximum
period, in hours, for which the
Almanac time is valid when
the GPS is reset.
Optional 720 0-4320
[EphemerisUsab
leTime
<expiry-interv
al(0-168)>]
Indicates the maximum
period, in hours, for which the
Ephemeris time is valid when
the GPS is reset.
Optional 4 0-168
[IntervalToRea
dGPSTime
{Hourly |
Daily |
Monthly |
Yearly}]
Indicates the interval after
which the NPU should obtain
the GPS time for frame
synchronization, and send it
to the AU.
Optional Daily
 Hourly
 Daily
 Monthly
 Yearly
[TimeToReadGPS
Time
<HH:MM:SS,DD/M
M>]
Indicates the time when the
NPU should obtain the GPS
time for frame
synchronization. .
Optional 04:05 HH:MM:SS,DD
/MM
Command
Modes
Global configuration mode