User's Manual

Chapter 3 - Operation and Administration Using the CLI NPU Configuration

4Motion 361 System Manual

The data is stored in an XML file called, prf_<SiteID>_yyyymmddhhmm.xml.gz in

the path,/tftpboot/management/performance. The system maintains this data for

a maximum of 24 hours after which it is deleted. It is recommended that you

periodically make a backup of these files on an external server.

You can enable/disable collection of performance data for each group separately.

This section describes:

 “Enabling Collection and Storage of Historical Performance Data” on page 361

 “Disabling Collection and Storage of Performance Data” on page 366

 “Displaying the Status of Performance Data Collection” on page 368

3.3.13.1 Enabling Collection and Storage of Historical Performance

Data

4Motion collects and stores performance data for the a number of system groups

(refer to Section 3.3.13). To enable collection and storage of performance data for

a group, run the following command:

To enable collection and storage of performance data for an NPU counters group:

npu(config)# pm-group enable npu {BckhlPort | MgmtPort | CascPort |

RelayDhcp | ServerDhcp | MsStateChangeFn}

To enable collection and storage of performance data for an AU counters group:

npu(config)# pm-group enable au { BsDeRegistrationTable |

BsIntegrity | BsMobilityTable | BsNetworkEntryTable |

BsTrafficTable | BsUtilizationTable | BsIdleModeTable |

BsFastFeedbackCQIHandlingTable | BsAckNackChannelHandlingTable |

BsEndTransactionUpdateTable | BsDlDataZoneFrameHistogramsTable |

BsTxR1NetTrafficTable | BsRxR1NetTrafficTable |

BsTxR1TotalTrafficTable | BsRxR1TotalTrafficTable |

BsDLHARQSbDropsTable | BsDLHARQTransmissionTable | BsGeneral |

Bsallmsbasicmode | Bsspecificmsadvancedmode}