User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 638 System Manual
Three levels of dynamic protection are available:
 No protection.
 Low protection level - protection against users with very poor channel
conditions. Should be used where the abusing users instantaneous rates are
far below the average instantaneous rate within the sector.
 Medium protection - protection against users with relatively poor or very poor
channel conditions. Should be used where the abusing users instantaneous
rates are below or far below the average instantaneous rate within sector.
A dynamic protection mechanism is implemented, in which the mechanism of
limiting resource allocations is automatically and dynamically activated when
needed.
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Scheduler parameters (refer to Section 3.8.29.1).
 Restore the default values of some or all of the Scheduler parameters (refer to
Section 3.8.29.2).
You can display configuration and status information for the Scheduler
parameters of a selected or all existing BSs (refer to Section 3.8.29.3).
3.8.29.1 Configuring Scheduler Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# scheduler [scheduler-mode {equalRate | equalTime} ]
[dl-abuse-protection-level {none | low | medium} ] [ul-abuse-protection-level
{none | low | medium} ]
To apply the changes, run the following command:
npu(config-bs-66053)# scheduler-apply
To configure the Scheduler parameters:
Command
Syntax
npu(config-bs-66053)# scheduler [scheduler-mode {equalRate |
equalTime} ] [dl-abuse-protection-level {none | low | medium} ]
[ul-abuse-protection-level {none | low | medium} ]