User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 619 System Manual
3.8.23.3 Restoring Default Values for Ranging Configuration
Parameters
To restore one or all of the Ranging General parameters to their default values,
run the following command:
npu(config-bs-66053-ranging)# no general [start-of-rng-codes] [max-cellradius]
You can restore only one parameter to its default values by specifying only this
parameter. For example, to restore only max-cellradius to the default value, run
the following command:
npu(config-bs-66053-ranging)# no general max-cellradius
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all Ranging General parameters to their default value, run the following
command:
npu(config-bs-66053-ranging)# no general
max-cellradius
{one | two | four |
eight | fifteen |
twentyThree |
thirty}
The Maximum Cell Radius (in
km)
Optional two
 one
 two
 four
 eight
 fifteen
 twentyThree
 thirty
Command
Modes
bs ranging configuration mode
NOTE
Refer to Section 3.8.23.2 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-ranging)# no general [start-of-rng-codes ]
[max-cellradius ]