User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 613 System Manual
npu# show ctrltrafficqos-all bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show ctrltrafficqos-all bs
Command
Syntax
npu# show ctrltrafficqos-all bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display all Control Traffic QoS
Marking Rules parameters of
a specific BS. Do not specify
a value for this parameter if
you want to display all Control
Traffic QoS Marking Rules
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
IntraASNDSCP :<value>
IntraASN802.1pPriority :<value>
InternalManagementDSCP :<value>
InternalManagement802.1pPriority :<value>
Command
Modes
Global command mode