User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 610 System Manual
3.8.21.5 Displaying Configuration Information for Control Traffic QoS
Marking Rules Parameters
You can display the current configuration information for the following
parameters tables:
 Internal Management (refer to Section 3.8.21.5.1)
 Intra ASN (refer to Section 3.8.21.5.2)
 All (refer to Section 3.8.21.5.3)
3.8.21.5.1 Displaying Configuration Information for Internal Management Traffic
QoS Marking Rules Parameters
To display configuration for the Internal Management Traffic QoS Marking Rules
parameters, run the following command:
npu# show ctrltrafficqos-intmngmnt bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Internal Management Traffic QoS Marking Rules
parameters of BS 66053, run the following command:
npu# show ctrltrafficqos-intmngmnt bs 66053
Do not specify this parameter if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show ctrltrafficqos-intmngmnt bs
Privilege
Level
10
Command
Modes
bs control traffic qos marking rules (ctrltrafficqos) configuration mode
Command
Syntax
npu# show ctrltrafficqos-intmngmnt bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1