User's Manual

Chapter 3 - Operation and Administration Using the CLI Managing BSs
4Motion 603 System Manual
3.8.20.6 Displaying Configuration Information for Bearer Traffic QoS
Marking Rules
To display configuration for the parameters of a specific or all Bearer Traffic QoS
Marking Rules, run the following command:
npu# show bearertrafficqos bs [<(1 to 16777215 StepSize 1)> number <(1 to
16383 StepSize 1)>]
Specify the BS ID and Bearer Traffic QoS Marking Rule number if you want to
display configuration for a particular Bearer Traffic QoS Marking Rule. For
example, to display the parameters of Bearer Traffic QoS Marking Rule 1 in BS
66053, run the following command:
npu# show bearertrafficqos bs 66053 number 1
Do not specify these parameters if you want to view configuration information for
all existing Bearer Traffic QoS Marking Rules. To display information for all Bearer
Traffic QoS Marking Rules, run the following command:
npu# show bearertrafficqos bs
Command
Syntax
npu(config-bs 66053)# no bearertrafficqos <(1 to 16383 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16383
StepSize 1)>
The Bearer Traffic QoS
Marking Rule number
Mandatory N/A 1-16383
Command
Modes
bs configuration mode
Command
Syntax
npu# show bearertrafficqos bs [<(1 to 16777215 StepSize 1)> number <(1 to 16383 StepSize 1)> ]